This is the four function Command Centre with four pneumatic buttons for two pumps, blower and light and a dial for temperature control. The Unit is manufactured by Tecmark cororation and is seen in use on many older Spas and Hot Tubs including Jacuzzi. This unit is rated at 12VAC and 50/60hz - other votage options are available, but not stocked by us. For full details of these Tecmark Command Centres, please ready below or visit the tecmark website http://www.tecmarkcorp.com/pdfs/CatSpaSideControls.pdf
Command Centers® are complete spa-side control packages designed for durability and user convenience in both new installations and replacement applications. They are available with two, three and four transmitter button configurations, and are equipped with a remote sensing thermostat, power cord, equipment status indicating lights and optional digital temperature readout.
The Command Centers® utilize an electronic thermostat designed, developed and manufactured by Tecmark® in our Mentor, Ohio facility. These units feature a thermistor/bulb assembly for remote temperature sensing. All thermostats are calibrated to open on temperature rise at the UL/CSA maximum allowable set point with the shaft at the high stop position and are intended for pilot duty control of heater contactors. Standard thermistor cable length is 60" (1.5m) with a 5/16" (8mm) OD bulb for thermowell installation.
Tecmark® Command Center® technology incorporates a unique, tactile thermostat adjustment knob with each notch equal to approximately 1° F (.56°C) temperature The Command Centers® feature high volume, miniature air transmitters for operation single function or four function switching controls. The faceplate design allows serviceability of individual transmitters without having to replace the entire unit. design conserves space and it is easily retrofittable to existing applications.
The Command Center® is primarily used at the spa-side to regulate the water temperature, and to control, via the air transmitter buttons, a variety of electrical devices including motors, lights, pumps, air blowers, and other associated equipment.
•One piece faceplate/housing construction utilizes durable thermoplastic materials •Tactile thermostat adjustment knob •Multicolor LED equipment status indicators •Factory installed double-sided foam mounting gasket •Electrical connections via 18/5 SJTW-SJTW-A water resistant cord with 5-pin plug •Pressure connections accept 1/8" (3mm) or 1/16" (1.5mm) I.D. tubing •60" (1.5m) thermistor cable with 5/16" (8mm) O.D. bulb •Allows serviceability of transmitters without replacing the entire unit •Conforms to UL and CSA standards under UL file E110332; low 12 volt safety control voltage acceptable worldwide (electronics comply with CE regulation)
•12, 120 OR 240 VAC, 50/60 Hz (factory set) •Digital display factory set to display water temperature in degrees F or degrees C. Temperature will flash intermittently at temperatures above 109° F (43° C) •Two, three and four air transmitter configurations available with faceplate size equal to the previous two-button faceplate •Optional retrofit plate available for existing three and four button installations. •Optional thermistor cable lengths •Power cords in 6' (1.8 m), 10' (3.0 m) and 25" (7.6 m) lengths •Units may be individually carton packaged or bulk packed
Ratings and Specifications:
•Input voltage: 12, •Field-tested critical components specifically selected to operate reliably in temperature extremes of 32° F (0° C) -140° F (60° C) •100,000+ cycle life under full mechanical, electrical and thermal loads. •Electrical rating allows pilot duty control of heater contactors •Thermostat contacts are designed to open on temperature rise at the UL/CSA maximum allowable setpoint with the adjustment shaft rotated to the full clockwise position •Switching differential: Approximately 1° F (.56° C) •100,000+ cycle life under full mechanical, electrical and thermal loads
Please Note: The image/s representing the product/s you are purchasing may appear aesthetically slightly different from the actual product. This may be due to necessary upgrades or minor changes for that model. If you have any doubts about what you are ordering, please give us a call on: 01633 244555